Newbie here but been surfing for a few days whilst the cables were delivered to make sure I had some knowledge of how to connect.
However I'm unable to connect..
Any ideas.. Breakdown below..
2013 MTS1200 GT with Tuneboy. (Mitsubish ECU I believe) Melcodiag 18.104.22.168 ELM 327 with Chip FT232RL USB. The log doesn't show ELM version. Lonelec DDA cable Windows 10 - Drivers set up ok Device manager checked and no errors. Com ports aligned from device manager and Melcodiag each time. Com port 3 /4 & 5 tried. Baud rate 9600. Others won't connect/support. tried all 3 options of the bike. Bike is powered up but not started (However is does turn off after about 30 seconds as it's not been started, Not sure once I get connection if it will stay powered on or not)
It just won't connect at all. ]
Get pop up error can't init elm!
Any help or tips I've missed please let me know.
Log below. "File generated On 9/6/2018 9:42:59 PM" "Software version 22.214.171.124" "ELM version : " "Auto Detect Bike = " "User Bike = MTS 1200 2013" "CAN Bike = " "Main ecu is not detected" "BBS ecu is not detected" "DashBoard ecu is not detected" "Ecu = " "Hardw = " "Softw = " "OilService = NO" "DesmoService = NO" "" "Vin = " "DTC = " "388F417A"
Checking the com port speed and speaking to one of the lads on another forum The com port is defaulting itself to 9600. Will try on Sunday by changing the baud rate and hopefully I’ll get it connected then. Will updat eonc ei get chance to mess with it.